Modern ovens combine a heating system, electronic controls, safety sensors, and (on gas units) a fuel-delivery system into a single appliance — and any one of those can fail independently. A misfiring igniter on a gas oven and a burned-out bake element on an electric oven both produce “won’t heat” symptoms but require completely different diagnostic and repair paths. That’s why oven repair services are usually a poor DIY job and a good fit for a factory-certified technician — especially on premium built-in wall ovens, where misdiagnosis can cost hundreds in unnecessary parts.

Common oven problems our team handles:

• Oven won’t heat at all — electric: bake element, broil element, or thermal fuse. Gas: igniter, gas valve, or pilot light.
• Oven heats but won’t hold temperature — temperature sensor (RTD probe), thermostat, or control board calibration
• Oven temperature is way off (too hot or too cool) — temperature sensor failure or oven thermostat calibration drift
• Oven door won’t latch or unlock after self-clean — door lock motor, latch assembly, or control board
• Oven control panel unresponsive or stuck — control board, membrane switch, or power supply issue
• Gas oven repair — won’t ignite or weak flame — igniter is the #1 culprit (silicon carbide or silicon nitride), followed by gas valve and flame sensor
• Convection fan not running — convection motor, control relay, or thermal fuse
• Strange smells (gas, electrical, or burning) — stop using the oven and call us immediately, these are not problems to wait on
• Error codes displayed — F1, F2, F3, F9 and brand-specific codes; we have manufacturer service manuals for every major brand

Our oven repair services team works on every oven type — freestanding ranges, slide-in ranges, single and double wall ovens, gas, electric, dual-fuel, and convection units — across every major brand.